Specifications

All data valid at 23 °C after 30 minutes warm up

Table 1. Technical and electrical features
Technical and electrical features
Bandwidth: 1.0 GHz
Propagation Delay: 7 ns
Rise Time: < 0.5 ns
Max Input Voltage (no adapter) 1 Vpp (Peak, CAT I)
Max Input Voltage (with Adapter) [1] 10 Vpp (Peak, CAT I)
Input Resistance: 2 MΩ
Input Capacitance: <1.2 pF
Input Dynamic Range: ±2V
Input Common Mode: 0V
(DC) to 1 GHz Range: ±2V > 0
Common Mode Rejection Ratio: 45 dB @ 1 MHz
DC Attenuation: 1:1 ±2%
Input Noise: 8 mVpp
Electrostatic Protection (HBM):

>8 kV

[1] The maximum allowable input is 10 Vpp. Exceeding this value may permanently damage the probe’s active input stage. For best accuracy and linearity, it is recommended to operate at or below 1 Vpp.

[2] Installation Category (Overvoltage Category) I (CAT I):

This instrument is intended for signal-level measurements on electronic, telecommunications, and special equipment circuits that are not directly connected to mains power. Transient overvoltages in these environments are lower than those encountered in Installation Category II.

Table 2. Mechanical specifications
Mechanical specifications
Approximate Weight: 170g (Not including accessories)
Cable Length: 100 cm
Length of Input Leads: 15 cm
Dimensions (LxWxH): 171.5 x 24 x 24 mm (Without a cap and cable)
Table 3. Environmental Specifications
Environmental Specifications
Temperature range operating: 0 °C to +40 °C
Temperature range non-operating: -20 °C to +70 °C
Altitude operating: 5000 m
Humidity: 25 - 85% non-condensing
Table 4. Inputs and Outputs
Inputs and Outputs
Pogo Pins Differential Input 2
USB-connector for Power ( USB -A) 5V - 500mA
SMA Connector RF Signal